Firmware Updates / Software Downloads

Transceiver

Model name IC-7610
Download Type Firmware
Version Version 1.06
Update 2018/03/01
Notes

Changes in this version

  • Fixed an issue that occasionally caused unexpected action during reception.
  • Fixed an external modulation input level problem.
  • Improved the transmitting/receiving signal quality.
  • Fixed an issue that will cause hangs up under the certain situations.
  • Improved the external display output signal.

To update the firmware

  • Thoroughly read Section 6, SD CARD/USB FLASH DRIVE, in the BASIC MANUAL and the Section 13, UPDATING THE FIRMWARE, in the ADVANCED MANUAL, and follow the instructions displayed on the IC-7610.
  • BE SURE to make a backup copy of your data settings to an SD card/USB flash drive before installing the firmware update.
  • The firmware will be updated to the following versions.
    Main CPU: 1.06
    Sub CPU: 1.02
    Front CPU: 1.01
    FPGA: 1.05
File Type ZIP
File Size 7.64MB
Manual IC-7610

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous